Ghost Controls Keypad & Intercom Repair Nationwide

Ghost Controls Keypad & Intercom Repair: The Las Vegas Owner’s Guide

Ghost Controls keypad and intercom repair in Las Vegas typically runs $195 – $415 installed, depending on whether we’re replacing the keypad module, the intercom board, or both. We stock Ghost Controls-compatible replacement parts on our trucks and can have most keypad swaps done same-day in the Vegas valley. Most owners discover the failure the same way: the keypad works fine at 7 a.m., then by noon the gate won’t respond, the backlight flickers, or the intercom speaker crackles out mid-conversation with a delivery driver.

Call (725) 220-0280

You’re not dealing with a generic opener here. Ghost Controls builds its keypads and intercom modules to talk to specific control board firmware versions, and mismatched parts cause intermittent faults that mimic wiring problems. That’s the #1 reason we see DIY replacements go sideways in Las Vegas: the aftermarket part looks identical but won’t handshake with the board.

Key takeaways:

• Most Ghost Controls keypad or intercom repairs in Las Vegas run $195 – $415 installed
• We carry OEM and quality aftermarket Ghost Controls-compatible parts on the truck
• Written price before we start, 365-Day Done Right Promise on every repair
• Call (725) 220-0280 and tell us what it’s doing, or not doing, and we’ll figure it out

Which Ghost Controls Models This Applies To

Ghost Controls ships several keypad and intercom configurations across its lineup, and the part you need depends on two things: your opener series and whether the keypad is wired or wireless. The biggest compatibility gotcha we see in Las Vegas is with the AXDP and HDP series, where a newer keypad revision won’t sync with older control board firmware. We’ve had customers show us a brand-new keypad that a previous tech installed, only to find the board needed a firmware flash before the keypad would register a single code.

Here’s how to identify what you have for certain. Wired Ghost Controls keypads usually have a model sticker on the back of the housing; look for a number starting with AXD or HDP. Wireless keypads broadcast on a paired frequency to a receiver module near the control board, and those fail differently: the keypad lights up, but the gate never receives the command. Intercom modules, used mostly on multi-tenant or long-driveway Vegas properties, are matched to the opener by a small ID sticker on the intercom board itself. If that sticker is bleached out by the sun (common here after three summers), we can still match it by the board’s pin layout.

On the OEM-versus-aftermarket question for Ghost Controls specifically: OEM parts cost more but the firmware compatibility is guaranteed. Aftermarket quality varies widely. We test aftermarket keypads on a bench before installing them because roughly one in five won’t talk to older Ghost Controls boards. We’ll be straight with you about which makes sense for your opener and your budget before we order anything. For Ghost Controls, we lean OEM on intercom boards and are more flexible on keypads.

Calder Gate Repair is an independent service provider, not affiliated with Ghost Controls. We stock parts compatible with their systems and service Ghost Controls openers across Las Vegas every week. We also stock parts for LiftMaster, Mighty Mule, and DoorKing openers, so if you have a mixed setup at your property, one visit can cover it.

Signs Your Ghost Controls Keypad or Intercom Is Failing

• Keypad lights up but gate won’t move. The keypad is transmitting, but the receiver module or board input isn’t registering the signal. This is the classic “looks fine, does nothing” failure we chase down in Las Vegas at least twice a week.
• Buttons need multiple presses or work intermittently. Ghost Controls keypads use membrane switches that wear out from UV and heat. A button that works “sometimes” is a failed membrane, not a wiring problem, and it will only get worse.
• Intercom speaker crackles, buzzes, or goes silent. Moisture intrusion into the intercom housing is common in Las Vegas despite the dry air; irrigation overspray and rare heavy monsoon downpours are the two biggest culprits we find.
• Keypad beeps but rejects codes that worked yesterday. The keypad’s memory chip may be corrupting, or the control board’s power supply is sagging enough to scramble the stored code table. We see this on openers five years and older.
• Backlight flickers or stays on constantly. Persistent backlight means the keypad is seeing voltage it shouldn’t, usually from a failing transformer or a short in the low-voltage wiring run from the house to the gate.

Replacement Cost & What’s Included

Here’s what you can expect to pay in Las Vegas for Ghost Controls keypad and intercom repair, installed by a uniformed, background-checked technician:

• Wireless keypad replacement: $195 – $285 installed, including the new keypad, receiver pairing, and a full system test
• Wired keypad replacement: $225 – $325 installed, including new keypad, wiring verification, and weather-seal replacement
• Intercom module repair or replacement: $285 – $415 installed, depending on whether the board can be repaired or needs replacement
• Keypad plus intercom combined: $380 – $550 installed when both have failed or one has damaged the other

The driver on price is usually part cost, not labor. A wired Ghost Controls keypad takes us about 45 minutes to swap and test; an intercom board can take two hours if the wiring has been baking in the Vegas sun and needs new connectors. Every quote we give in Las Vegas is a written price before we start. The number on the invoice is the number we agreed to at the door. Period. And every repair carries the 365-Day Done Right Promise: if the keypad or intercom fails within a year, we come back and make it right at no charge.

DIY or Call Us?

Keypads and intercoms are low-voltage parts, so there’s no shock hazard that requires a license, and a careful owner can certainly swap a wireless keypad following Ghost Controls’ pairing instructions. If that works, you’ve saved yourself a service call and learned something about your gate. But here’s where DIY goes wrong on Ghost Controls systems specifically: you replace the keypad, it still doesn’t work, and now you have a new part installed on an old problem. The issue was the receiver module, or the board input, or a corroded low-voltage connection back at the opener, and now you’ve spent two evenings and $150 chasing a symptom instead of the cause.

We also don’t love seeing homeowners open intercom housings themselves. The intercom board is packed with small relays and surface-mount components that a slipped screwdriver can destroy in half a second. If your Ghost Controls keypad or intercom is doing anything unusual, call us at (725) 220-0280 before you order parts online. We’ll ask what it’s doing or not doing, and we’ll tell you honestly whether it’s a five-minute fix or a swap we should handle.

FAQs

Call Calder Gate Repair Las Vegas

If your Ghost Controls keypad or intercom is acting up, don’t spend another evening punching buttons and hoping. Call (725) 220-0280 and tell us what it’s doing, or not doing, and we’ll figure the rest out from there. You’ll get a written price before any work starts, a live person on the phone 24/7, and a repair backed by the 365-Day Done Right Promise. Nico Alvarez and the Calder Gate Repair team serve the whole Las Vegas valley, from Summerlin driveways to commercial entries near the Strip.

Written by Nico Alvarez, Owner & Lead Gate Technician, Calder Gate Repair Las Vegas at Calder Gate Repair Las Vegas, serving Las Vegas and nearby areas.